Physical-Link Failure Indicator; Display Link-Failure Indicator Sensitivity - 3Com CoreBuilder 7000 Management Manual

Physical-Link Failure
Indicator
Display Link-Failure
Indicator Sensitivity
The following commands allow you to configure the physical-link failure
indicator.

Display Link-Failure Indicator Sensitivity

Update Link-Failure Indicator Sensitivity
For more information about the physical link failure indicator,
"Physical-Link Failure Indicator" on page 128 in the Operations Guide.
Displays the enable/disable status and the sensitivity for the link-failure
detection mechanism of the CoreBuilder 7000 family ATM switch. For
more information, "Link-Failure Detection Sensitivity Control" on page
129 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 11 1
The following message is displayed:
Current port link down indication status is: Enabled
Sensitivity: Medium

Physical-Link Failure Indicator

(1) SET: Switch setup
(11) PLD: Port link down indication
(1) GET: Get Port link down sens
1 1 11 1
The link-failure mechanism status for the switch is
displayed.
Current port link down indication
status is: Enabled/Disabled
Sensitivity: Low/Medium/High
125