Switch Redundancy; Display Switch Redundancy Status - 3Com CoreBuilder 7000 Management Manual

C 3: G
64
HAPTER ENERAL

Switch Redundancy

Display Switch
Redundancy Status
Redundancy mode:
Switch Engine Slot 1
Switch Engine Slot 2
I/F card for communication:
Inter-Switch Communication status: Established
Configuration status
T
ASKS
The following commands allow you to configure Switch Redundancy:

Display Switch Redundancy Status

Set Switch Redundancy Mode
Set Redundant Switch Mode
Force I/F for Redundancy Communication
For more information about switch redundancy, see Chapter 10 in the
Operations Guide.
Displays the switch redundancy status of the CoreBuilder 7000 family
ATM switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 13 1
The following information is displayed:
Enhanced
: Redundant Standby
: Active
Slot 3
: Synchronized
(1) SET: Switch setup
(13) SRS: Switch Redundancy setup
(1) STA: Display switch red. status
1 1 13 1
The switch redundancy status of the CoreBuilder 7000
family ATM switch is displayed.
Information is displayed as shown in the example
below.