Get Node Index
Displays the number of PNNI nodes defined in the switch and the current
PNNI node index. The default node index value is 1 and cannot be
changed for this version.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message is displayed:
Number of PNNI nodes is 1. PNNI node index is 1.
Set Node Index
Displays the number of PNNI nodes defined in the switch and updates the
current PNNI node index. The default node index value is 1 and cannot be
changed for this version. If the current node works on three different
levels, for example, the node has three possible indexes: 1, 2 and 3.
(1) SYS: Platform config
(1) SET: Switch setup
1 1 10 4 3 1 2
The number of PNNI nodes defined in the switch, and
the number of the current PNNI node index is
displayed
Number of PNNI nodes is <n>. PNNI node
index is <i>.
1 1 10 4 3 1 2
Configuring PNNI Nodes
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(1) SEN: Select Node
(2) GNI: Get Node Index
375