Set Node ID
Updates the ID of the PNNI node to a new address. A change to the node
lD takes place after the administrative status is set to UP or after the next
reboot. For more information, see "Set Node Administrative Status to
UP" on page 378.
There are several PNNI operations in the LMA that can only be performed
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
node id
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.F6
The following message is displayed:
New Node ID was set. Node Id:
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.F6
The node ID is updated to its new value.
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
Format or Range
20 bytes
1 1 10 4 3 3 4 3
The current PNNI node id is set to the new address.
New Node ID was set. Node Id:
1 1 10 4 3 3 4 3
Configuring PNNI Nodes
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(4) NID: Node ID
(3) SID: Set Node ID
391