Set Node Name - 3Com CoreBuilder 7000 Management Manual

Set Node Name

Updates the name assigned to the current PNNI node. A change the node
name takes place immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message is displayed:
Node Name was SET to: 3Com World
The name of the node is updated to 3Com World.
Parameter
PNNI node name
1 1 10 4 3 3 5 2 3Com World
Configuring PNNI Nodes
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(5) NAM: Node Name
(2) SNA: Set Node Name
Format or Range
Up to 30 alphanumeric characters
1 1 10 4 3 3 5 2 [parameters]
The name of the current PNNI node is updated.
Node Name was SET to: <name>
393