Update Signaling Protocol Version - 3Com CoreBuilder 7000 Management Manual

Update Signaling
Protocol Version
Updates the signaling protocol version of the ports of the CoreBuilder
7000 family ATM switch.
This command causes the new protocol version to be activated in the
current session. The new value is not stored in flash until you use the SAV
command ("Save Signaling Protocol Configuration" on page 206).
If the new value of the protocol version is not stored in flash, the system
reverts to the previous value of the protocol version the next time it
reboots.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Protocol version
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 5 4 3.2 1
The following message is displayed:
Parameter was set. Use 'SAVE' to save it on flash.
The signaling protocol version for port 3.2 is updated to 3.1.
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol setup
(4) SPV: Set protocol version
Format or Range
slot.port (0.0 for all ports)
0 for version 3.0
1 for version 3.1
2 for version 4.0
1 1 4 5 4 [parameters]
The signaling protocol version is updated for the
specified port.
Parameter was set.
Signaling Setup 205