Set And Save Interface Mode - 3Com CoreBuilder 7000 Management Manual

C 5: C
112
HAPTER ONFIGURING
Set and Save
Interface Mode
I M
NTERFACE ODULES
Sets and saves the interface mode of the selected port as SDH or SONET.
You are prompted to specify a port and a mode.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Interface Mode
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 5 1 4 3.2 1
The following message is displayed:
Setting interface mode for port <3.2> completed successfully.
The interface mode of port 2 in slot 3 of the selected interface is set to
SONET and saved.
(5) IFC: Interface cards
(n) IFn; (n=1,4)
(4) SPM: Set & save
interface mode
Format or Range
slot.port (0.0 - For all)
0 for SDH
1 for SONET
[parameters]
1 5 n 4
The interface mode of the selected port on the
interface card is set and saved.
Setting interface mode for port
<slot.port> completed successfully.