3Com CoreBuilder 7000 Management Manual page 107

Interface card HW version is
If Physical
id type
--- ----------- ------------------- ------------
6.1 OC3-SC (B) Multi mode fiber
6.2 OC3-SC (B) Multi mode fiber
6.3 OC3-SC (B) Multi mode fiber
6.4 OC3-SC (B) Multi mode fiber
6.5 OC3-SC (B) Multi mode fiber
6.6 OC3-SC (B) Multi mode fiber
6.7 OC3-SC (B) Multi mode fiber
6.8 OC3-SC (B) Multi mode fiber
5
Media
type
Table 18 describes the
command.
Table 18 Interface Parameters
Parameter
If ID
Physical Type
622/OC-3 Compatibility
Type *
Media Type
Operational Status
Display Interface Card Parameters
Operational Admin
status status
-------- ----- ------
Up & Connect Enabled
Up Enabled
Up Enabled
Up Enabled
Up Enabled
Up Enabled
Up & Connect Enabled
Up & Connect Enabled
i
nterface module parameters displayed by the
Description
Interface ID. The port ID number for each of the card's
ports.
The port interface type (for example, OC3-SC, DS-3
BNC). The type determines the interface, including the
type of connector.
Indicates compatibility of this OC-3 Module with a 622
Module:
"A": Will not operate with a 622 module installed
"B": Will operate with a 622 module installed
The type of fiber used by the port (for example, coaxial
cable, multi-mode fiber).
The operational status of the port. It can be:
Up & connect - Operating and connected to
external device
Up - operating but not connected to external device
Down - Not operating
Not exist - Slot empty
Incompatible - Module incompatible
Frame Clock
type mode
SONET Intern
SONET Intern
SONET Intern
SONET Intern
SONET Intern
SONET Intern
SONET Intern
SONET Intern
107