Display Virtual Channels At Port; Display Virtual Channel To Ime Address - 3Com CoreBuilder 7000 Management Manual

Display Virtual
Channels at Port
Display Virtual
Channel to IME
Address
The following commands allow you to display the virtual channels
(connections) established at a port.

Display Virtual Channel to IME Address

Display Virtual Channel to Static Address
Display Virtual Channel to De-Registered Address
For information about establishing port connections, see "External Links
– ATM Connections" on page 99 in the Operations Guide.
Displays information about virtual channels established at a specific port.
Specify the virtual channel by specifying its VPI/VCI values. The virtual
channels were created dynamically (SVCs).
Command Actions
Enter the menu sequence:
Enter a parameter at the prompt
Parameter
Port ID
VPI
VCI
Direct access sequence:
Command Result
System action taken:
System message display:

Display Virtual Channels at Port

(3) CON: Connections
(3) PRT: ATM ports
(1) IME: Conns of IME addresses
Format or Range
slot.port
A for all VPI values
any value for all VPI values
3 3 1 [parameters]
The connection information for the specified port is
displayed.
Information is displayed as shown in the example on
pages 174.
173