Enable/Disable Ilmi Channel Polling - 3Com CoreBuilder 7000 Management Manual

Enable/Disable ILMI
Channel Polling
Enables or disables ILMI channel polling and saves the ILMI channel
polling status for the specified port in the CoreBuilder 7000 family ATM
switch. For more information, "ILMI Connectivity Polling" on page 41 in
the Operations Guide.
ILMI channel polling must be enabled if the change of attachment-point
facility (COAP) is enabled (see "Enable/Disable Change of
Attachment-Point" on page 148 ).
To set the polling interval, see "Update ILMI Channel Polling Interval" on
page 139.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
ILMI polling
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 5 2 3.2
The following message is displayed:
ILMI polling is set to ENABLED
The polling status of port 2 in slot 3 is enabled and is saved to flash.
(1) SET: Switch setup
(8) IME: ILMI setup
(5) POL: Polling setup
(2) SST: Set&Save Polling status
Format or Range
slot.port
0 to disable ILMI polling
1 to enable ILMI polling
1 1 8 5 2 [parameters]
ILMI polling for the selected port is updated
immediately and is saved in flash.
ILMI polling is set to ENABLED/DISABLED
1
ILMI Setup 137