Command Description - 3Com CoreBuilder 7000 Management Manual

A T G
20
BOUT HIS UIDE
Command
Description
A
B
C
D
Chapters 2 through 13 provide information about all the LMA
commands. For each command, a standard format is used to describe the
command. A sample command description is presented in Figure 1
below:
Command Actions
Enter menu sequence:
Enter parameter at prompt
Parameter
New password
New password again
Direct access sequence:
Command Result
System action:
Figure 1 LMA Command Description Format
As shown in Figure 1, the command description presented in the manual
is divided into four sections:
Table 3 Command Description Sections
Key Section
A Menu sequence
B Parameters
(1) SYS: Platform config
(1) SET: Switch setup
(1) PAS: Password setup
(1) REA: Set Read-access Password
Format or Range
Up to eight alphanumeric characters
1 1 1 1 [parameters]
The read-access password is updated.
Description
The menu options that need to be selected in order
to execute the command. All the levels/sublevels to
be followed are presented.
The parameters to be entered after the menu
sequence and the format they must be entered. If no
parameters are necessary, this section does not
appear in the command description.