Modify Scope Mapping Table - 3Com CoreBuilder 7000 Management Manual

Modify Scope Modifies parameters in the scope mapping table. A change to the scope
Mapping Table mapping table parameters takes place after the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Scope Mapping Table Parameters
Table 57 shows the parameters required by the command.
Table 57 Scope Mapping Table Parameters
Name
Table Index #
PNNI Level
Parameter
Table index
PNNI level
Description
The row number in the scope mapping table.
The hierarchical level in the network structure.
Managing the Scope Mapping Table
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(5) SMT: Scope Mapping
Table Config
(2) MST: Modify Scope Mapping
Table
Format or Range
1 to 15
0 to 104
1 1 10 4 4 5 2
The specified parameters are updated with the new
values.
PNNI Scope Mapping Table ROW NEW value
437