Update Network Prefix - 3Com CoreBuilder 7000 Management Manual

Update Network
Prefix
Updates the network prefix in the CoreBuilder 7000 family ATM switch.
The network prefix update takes place after the next reboot
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Network Prefix
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 6 2
The following prompt is displayed:
Enter parameter(s): 'Net Prefix(13 bytes - First byte: 47,
39)'
Enter a Network prefix.
(1) SET: Switch setup
(6) SNP: Switch Network Pref setup
(2) SET: Set & save Network Prefix
Format or Range
13 bytes—First byte: 47, 39
1 1 6 2 [parameters]
The network prefix is updated in flash memory. The
change takes place after the next reboot.
Enter parameter(s): 'Net Prefix(13
bytes - First byte: 47, 39)'
Network Prefix 63