Set Fast Auto-Configuration On/Off Status - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
150
HAPTER
Set Fast
Auto-Configuration
ON/OFF Status
ONFIGURATION
Sets the status of the fast auto-configuration for the specified port.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port number
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 9 2 4.1
The following prompt is displayed:
Enter parameter(s): 'Port id <slot.port>
The following message is displayed:
Fast Auto-Configuration is set to DISABLED.
(1) SET: Switch setup
(8) IME: ILMI setup
(9) FAC: Fast auto config setup
(2) SET: Set fast auto-config
ON/OFF status
Format or Range
slot.port
1 1 8 9 2 [parameter]
The fast auto-configuration status of the specified port
is set.
Fast Auto-Configuration is set to
ENABLED/DISABLED.