Update Nms Address - 3Com CoreBuilder 7000 Management Manual

Update NMS Address

Enter the new NMS address to update the NMS address of the
CoreBuilder 7000 family ATM switch. The default factory NMS address is
0.0.0.0. The address is updated after the next reboot of the switch.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
NMS address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 2 2 100.1.0.131
The NMS address is updated to 100.1.0.131.
Setting Up for Management
(1) SET: Switch setup
(2) MNG: Management setup
(2) NMS: NMS Setup
(2) SNS: Set & Save NMS Address
Format or Range
valid IP address
1 1 2 2 2 [parameters]
The NMS address is updated after the next reboot of
the switch.
NMS address was successfully set.
73