Display Auto-Configuration Status - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
130
HAPTER
Display
Auto-Configuration
Status
ONFIGURATION
Displays the auto-configuration status for the specified port of the
CoreBuilder 7000 family ATM switch. Auto-configuration determines, by
negotiation, the common protocol parameters to be used on the ILMI
channel. The status can be either enabled or disabled. For more
information, see "Auto-Configuration" on page 48 in the Operations
Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 2 1 3.2
The following message is displayed:
Auto-configuration is ENABLED.
(1) SET: Switch setup
(8) IME: ILMI setup
(2) AUC: Auto-Configuration setup
(1) GET: Get Auto-Config status
Format or Range
slot.port
1 1 8 2 1 [parameters]
The auto-configuration status for the specified port is
displayed.
Auto-Configuration is ENABLED/DISABLED.