Display Auto-Configuration Results - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
140
HAPTER
Display
Auto-Configuration
Results
ONFIGURATION
Displays results of the auto-configuration process for the specified port of
the CoreBuilder 7000 family ATM switch. Auto-configuration compares
the local and remote ports of two switches and reconfigures them to a
common signaling protocol - the lowest common value (version number)
of both ports.
For more information, "Auto-Configuration" on page 48 in the
Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Auto-Configuration Results Display
Table 19 describes the auto-configuration results displayed by the
command.
.
Table 19 Auto-Configuration Results
Name
Parameter Name Protocol parameter configured by auto-configuration
Local Value
Remote Value
AutoCfg Result
(1) SET: Switch setup
(8) IME: ILMI setup
(6) ACV:Auto-Config/Auto-Dis View
(1) CFG: View Auto Config result
Format or Range
slot.port
1 1 8 6 1
The auto-configuration results for the specified port
are displayed.
Information is displayed as shown in the example
below.
Description
Initial value of parameter in local switch
Value of parameter returned from peer switch
Final value of parameter in local switch determined by
auto-configuration
[parameters]