Mpoa Devices Configuration; Display Current Mps Configuration - 3Com CoreBuilder 7000 Management Manual

C 9: M
268
HAPTER ANAGING
MPOA Devices
Configuration
Display Current MPS
Configuration
MPOA Server Configuration
-------------------------
MPS-p1 keep-alive time:
MPS-p2 keep-alive lifetime:
MPS-p3 internetwork-layer protocols:
MPS-p4 MPS initial retry time:
MPS-p5 MPS retry time maximum:
MPS-p6 MPS give up time:
MPS-p7 default holding time:
LAN E S
MULATION ERVICES
The switch allows configuration of MPOA entities: MPS and MPC. The
configuration is general so that all MPSs and MPCs that request
configuration receive the same parameters.
Displays all the current settings of the MPS variables.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
2 5 1 1
The following information is displayed:
(2) LEM: LAN Emulation
(5) MPA: MPOA Devices Configuration
(1) MPS: MPOA Server Configuration
(1) DIS: Display current config
2 5 1 1
All the current settings of the MPS variables are
displayed.
Information is displayed as shown in the example
below.
10 (seconds)
35 (seconds)
{}
5 (seconds)
40 (seconds)
40 (seconds)
20 (minutes)