Set Default Atm Address - 3Com CoreBuilder 7000 Management Manual

C 13: C
384
HAPTER ONFIGURING AND
Set Default ATM
Address
M PNNI (F
ANAGING
Sets the last six bytes (ESI - End System Identifier) of the ATM address of
the current node to the default ATM address value. A change to the
default ATM address takes place after the next reboot.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 3 2 2
The following message is displayed:
ESI (6 bytes) of ATM ADDRESS was set to DEFAULT:
47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.F6.FF
The last six bytes of the ATM address are set to their default values.
In the example above, for clarity, the ESI of the ATM address is
underlined.
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(2) ADD: ATM Address
(2) SDF: Set default ATM Address
1 1 10 4 3 3 2 2
The default ATM address is displayed.
ESI (6 bytes) of ATM ADDRESS was set to
DEFAULT: <default address>
)
NLY