Reset All PNNI
Interface Parameters
to Default Values
Resets all the PNNI parameters for all interface ports to their default
values. The parameter reset takes place immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Confirm reset
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 4 3 y
The following message is displayed:
All PNNI interface parameters were set to their defaults
Setting Interface Parameters
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(3) SDF: Set all interface
parameters to defaults
Format or Range
y or n
1 1 10 4 4 3
All the parameters for all the interface ports are set to
their default values.
All PNNI interface parameters were set
to their defaults
433