Enable/Disable Change Of Attachment-Point - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
148
HAPTER
Enable/Disable
Change of
Attachment-Point
ONFIGURATION
Enables or disables the change of attachment-point mechanism for the
specified port in the CoreBuilder 7000 family ATM switch.
ILMI channel polling must be enabled if the change of attachment-point
facility (COAP) is enabled ("Enable/Disable ILMI Channel Polling" on
page 137).
Before enabling COAP, verify that all attached ATM edge devices support
ILMI 4.0. If they do not, they can fail.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Change of
attachment-point
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 2 1 3.2 1
The following message is displayed:
Change of attachment-point is set to ENABLED
The change of attachment-point status of port 3.2 is enabled.
(1) SET: Switch setup
(8) IME: ILMI setup
(8) COA: COAP setup
(2) SET: Set&save COAP status
Format or Range
slot.port
0 to disable change of attachment-point
1 to enable change of attachment-point
1 1 8 8 2 [parameters]
The change of attachment-point status is enabled or
disabled for the selected port immediately and is saved
in flash.
Change of attachment-point is set to
ENABLED/DISABLED