Display Qsaal Signaling Timers And Sscop Configuration - 3Com CoreBuilder 7000 Management Manual

C 7: C
216
HAPTER ONFIGURING
Display QSAAL
Signaling Timers and
SSCOP Configuration
V C
IRTUAL HANNELS
Displays the current QSAAL signaling protocol timer values and SSCOP
configuration parameters for the specified port. The timer values are
displayed in tenths of a second.
You update the timer values by changing the timer resolution. For more
information, "Update Protocol Timer Resolution" on page 212. The
SSCOP configuration parameters cannot be altered by the normal admin
LMA menus. If you need to alter SSCOP configuration parameters,
contact your 3Com technical support.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 4 3.2
The following information is displayed (1-9 are timers, 10-13 are
configuration parameters):
(1) SET: Switch setup
(4) SIG: Signaling setup
(4) QSA: Signaling QSAAL config
Format or Range
slot.port
1 1 4 4 [parameters]
The current QSAAL signaling protocol timer values and
SSCOP configuration parameters for the specified port
are displayed.
Information is displayed as shown in the example
below.