3Com CoreBuilder 7000 Management Manual page 144

C 6: ILMI C
144
HAPTER
AutoDiscovery and System
==============================================================
EIISP.
1 |Local Typewritten Tapeworm UniType|Interface Type |IME Type |
|node
|Local Mac
2
|00c0da60283e|00c0da69f258|Network Side|
|Parameter Name
|================|==============|==============|===============
|ILMI Version
3
|NNI Sig Ver
ONFIGURATION
Display of Local Switch
Enter:
1 1 8 6 2 3.3
The auto-discovery results display at port 3.3 of the local switch are
shown below. Section (1) shows that the local switch has been
configured to ATM interface type E-IISP and IME type network. The
auto-discovery process is shown by sections (2) and (3). Section (2) shows
that the IME type vis-a-vis the peer has been configured to Network.
because the local MAC address is less than the peer MAC address.
Section (3) shows that the local switch was originally configured to E-IISP
(local value) and the peer switch (remote value) was originally configured
to IISP. The result of the auto-discovery is that the local switch stays
configured at E-IISP.
-- Warning: PNNI protocol is disabled, converting PNNI ports
-- Auto Discovery is enabled on this port
-- Auto Discovery has succeeded on this port
|node
|Remote Mac
|Local Value
|ILMI 4.0
|EIISP
Display of Peer Switch
Enter:
1 1 8 6 2 4.3
The auto-discovery results at port 4.3 of the peer switch are displayed
below. Section (1) shows that the local switch has been configured to
ATM interface type E-IISP and IME type User. The auto-discovery process is
shown by sections (2) and (3). Section (2) shows that the IME type
vis-a-vis the peer has been configured to User because the local MAC
address is greater than the peer MAC address. Section (3) shows that the
Flags that affects the final results
|private |EIISP
|IME TYPE |
|Remote Value
|ILMI 4.0
|IISP
to
|Net |
|AutoCfg Result
|ILMI 4.0 |
|EIISP |