Update Subnet Mask Address - 3Com CoreBuilder 7000 Management Manual

Update Subnet Mask
Address
Updates the subnet mask address of the CoreBuilder 7000 family ATM
switch. The default factory subnet mask address is 255.255.255.0. The
subnet mask address is updated after the next reboot of the switch.
Run the integrated fast setup to configure this parameter.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Subnet mask address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 4 2 255.255.255.0
The Subnet Mask address is updated to 255.255.255.0.
Setting Up for Management
(1) SET: Switch setup
(2) MNG: Management setup
(4) MSK: Subnet Mask Setup
(2) SSM: Set & Save Subnet Mask
Format or Range
valid IP address
1 1 2 4 2 [parameters]
The subnet mask address is updated after the next
reboot of the switch.
Run integrated fast setup to configure
this parameter.
77