Reset All Configuration Parameters - 3Com CoreBuilder 7000 Management Manual

Table 14 Configuration Parameter Groups
Parameter
Block ID
Group name
Group ID
Maximum length
Actual length
No. of rec.
Reset All Resets all configuration parameters for the CoreBuilder 7000 family ATM
Configuration switch in flash memory to their factory default settings.
Parameters
If you need to retain Telnet connectivity while resetting the parameters,
use the command Reset All Configuration Parameters Except IP Address
instead (see "Reset All Configuration Parameters Except IP Address" on
page 90 ).
Table 15 shows the factory default values of the configuration
parameters.
Table 15 Configuration Parameter Default Values
Parameter
General
Signaling Version
Signaling Timers
EFCI threshold
Max Hop Count
ATM Interface Type
ILMI
ILMI version
Auto-Configuration
Auto-Discovery
COA
ILMI Timers
LANE Services
LANE Services (LECS & LES\BUS)
Resetting Configuration Parameters
Description
The id of the flash block in which the region is located.
Flash regions.
ID for the region.
Maximum length in bytes.
Actual length in bytes.
Number of records.
Set to
UNI 4.0
5 X Standard Defaults (for example, timer
resolution = 500)
50% congestion
7
UNI
4.0
Enabled
Enabled
Disabled
Default
Disabled
87