Ignore Interface Card Slot - 3Com CoreBuilder 7000 Management Manual

Ignore Interface
Card Slot
Updates the interface card ignore-slot parameter. The ignore-slot
parameter can take the values Ignore and Normal. For more information
"Display Interface Card Ignore-Slot Status" on page 114.
Use this command to disconnect an interface card from the switch
without having to physically remove it.
Use this command also to reset a module installed in a specified slot
without physically removing it: perform the command twice, first with
'Ignore' and then with 'Normal'.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Slot ID
Ignore slot status
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 3 5 3 0
The following message is displayed:
Status has been changed.
The ignore-slot parameter of slot 3 is set to Ignore.

Ignore Interface Card Slot

(3) LOA: Load system software
(5) SSI: Set 'ignore slot' status
Format or Range
3–6
0 for Ignore
1 for Normal
1 3 5 [parameters]
The ignore slot parameter is set to the specified value.
Status has been changed.
115