Enable Lan Emulation Services - 3Com CoreBuilder 7000 Management Manual

Enable LAN
Emulation Services
Enables the LAN Emulation services in the CoreBuilder 7000 family ATM
switch. The enable takes place after the next reboot.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 5 1 2
The following message is displayed:
LE services will be ENABLED on the next reboot.
LAN Emulation Services Setup
(1) SYS: Platform config
(1) SET: Switch setup
(5) SLE: LE setup
(1) LES: LE services setup
(2) ELS: Enable & save LE services
1 1 5 1 2
The LE services status is enabled after the next reboot.
LE services will be ENABLED on the next
reboot.
255