3Com CoreBuilder 7000 Management Manual page 198

C 7: C
198
HAPTER ONFIGURING
V C
IRTUAL HANNELS
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Parameter selector *
Parameter value
Direct access sequence:
* Only one parameter can be defined per command.
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 3 2 3.2 1 0
The following message is displayed:
Parameter was set. Use 'Save' to save it on flash.
The minimum VPI for port 3.2 is updated to 0.
(1) SET: Switch setup
(4) SIG: Signaling setup
(3) VCC: VPI/VCI range setup
(2) SET: Set Q93B config params
Format or Range
slot.port
1 for Min VPI
2 for Max VPI
3 for Min VCI
4 for Max VCI
1 1 4 3 2 [parameters]
The selected UNI VPI/VCI configuration parameters are
updated for the specified port for the current session.
Parameter was set. Use 'Save' to save
it on flash.