Make Primary Les Active - 3Com CoreBuilder 7000 Management Manual

Make Primary LES
Active
Re-establishes the primary LES of the ELAN as the active LES. When the
secondary LES of an ELAN is active instead of the primary LES, this
command causes LECs to be released from the secondary LES to join the
primary LES. Specify the ELAN name of the primary LES.
A secondary LES becomes the active LES on the failure of the primary LES
and it remains active even when the primary LES recovers. For more
information, see "Failure Recovery - Transferring Control to the
Redundant LES" on page 158 in the Operations Guide.
You need to perform this command on all CoreBuilder 7000 switches
with active LECS and verify the result.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
ELAN name
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
2 1 5 9 3 elan73_9
The following message appears:
Elan was set to primary.
The primary LES of the specified ELAN becomes the active LES
LAN Emulation Redundancy
(2) LEM: LAN Emulation
(1) LCS: LE Configuration Services
(5) LNT: LECS Network topology
(9) RDN: LE Service redundancy
(3) FEP: Force Elan to Primary
Format or Range
Up to 32 alphanumeric characters (see
ELANs" on page 290 in the Operations Guide
2 1 5 9 3 [parameters]
The primary LES of the specified ELAN becomes the
active LES.
Elan was set to primary.
311
"Display
)
.