Select Port For Interface Parameter Setting - 3Com CoreBuilder 7000 Management Manual

Select Port for
Interface Parameter
Setting
Selects the port for which the interface parameters will be set.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
port number
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 4 1 4.2
The following message is displayed:
Current port number is 4.2
Setting Optimization Metrics
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(1) SPT: Select Port
Format or Range
slot.port
1 1 10 4 4 1 [parameters]
The specified port is set to the active port, ready for
configuration
Current port number is <slot.port>
423