Display Change Of Attachment-Point Status - 3Com CoreBuilder 7000 Management Manual

Display Change of
Attachment-Point
Status
Displays the change of attachment-point status for the specified port of
the CoreBuilder 7000 family ATM switch. The change of
attachment-point mechanism, if enabled, causes the ILMI to restart on a
change of device attachment (disconnection or re-connection) at a port.
The result is either Enabled or Disabled. For more information,
"Configuring a Port on Change of Attachment" on page 51 in the
Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 8 1 3.2
The following message is displayed:
Change of Attachment Point is DISABLED.
(1) SET: Switch setup
(8) IME: ILMI setup
(8) COA: COAP setup
(1) GET: Get COAP ON/OFF status
Format or Range
slot.port
[parameters]
1 1 8 8 1
The change of attachment-point status for the
specified port is displayed.
Change of attachment-point is
ENABLED/DISABLED.
ILMI Setup 147