Enable Interface - 3Com CoreBuilder 7000 Management Manual

Enable Interface

Enables the interface card port. You are prompted to specify a port.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 5 1 1 3.2
Port 2 in slot 3 of the selected interface card is enabled.
The following message is displayed:
Enable port completed successfully.
(5) IFC: Interface cards
(n) IFn; (n=1,4)
(1) EIF: Enable interface
Format or Range
slot.port
[parameters]
1 5 n 1
The selected port on the interface card is enabled.
Enable port <slot.port> completed
successfully.
Enable Interface 109