3Com CoreBuilder 7000 Management Manual page 166

C 7: C
166
HAPTER ONFIGURING
V C
IRTUAL HANNELS
Calls routed to an ATM address are differentiated by their Call ID. The Call
ID is allocated by the switch at the time the call is initiated and uniquely
identifies the call in the CoreBuilder 7000.
More than one call can be routed to a single ATM address at one time.
For example, when a bridged Ethernet LAN is attached to a single LEC, all
calls to the stations on the LAN are transmitted to that LEC's ATM
address.
If you do not know the Call ID of the call whose information you want to
display, enter 0 for the Call ID and a list of calls routed to the ATM address
are displayed together with their Call IDs. You can read the desired Call ID
from this list according to the VPI/VCI number, for example.
Command Actions
Enter the menu sequence: (3) CON: Connections
Enter a parameter at the prompt
Parameter
For SVC: ATM address
member
For PVC: Port ID
Call ID
Direct access sequence:
Command Result
System action taken:
System message display:
Call Parameters
Table 23 shows the call parameters displayed by the command.
(2) RTG: Routing
(1) CLL: Calls
Format or Range
'slot''port''sequential number'
For example: 1102
slot.port
n (0 for all calls)
3 2 1 [parameters]
The information for the specified call is displayed.
Information is displayed as shown in the examples on
pages 169, 170 and 171.