Display Vp Tunnels At Port - 3Com CoreBuilder 7000 Management Manual

Display VP Tunnels at
Port
Displays parameters of the VP tunnels defined at a port of the
CoreBuilder 7000 family ATM switch. Table 34 describes the parameters
that are displayed by the command. For more information, see "VP
Tunneling" on page 5-101.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 9 3 1 4.1
The following information is displayed:
Tunnels on port <4.1>:
Vpi: < 0>
Type: NONE
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(3) TUN: Tunnels Setup
(1) GTN: Get Tunnels on Port
Format or Range
slot.port
1 1 9 3 1 [parameters]
Parameters of the VP tunnels for the specified port are
displayed
Tunnels on port <slot.port>:
< 1> < 2> < 3>
NONE NONE P2P
Configuring VP Tunnels
< 4> < 5> < 6>
P2P NONE NONE
227
< 7>
NONE