Update Ilmi Channel Polling Interval - 3Com CoreBuilder 7000 Management Manual

Update ILMI Channel
Polling Interval
Updates and saves the ILMI channel polling interval for the specified port
in the CoreBuilder 7000 family ATM switch. The ILMI polling interval is
normally set to 30 seconds. For more information, "ILMI Connectivity
Polling" on page 41 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Polling interval
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 5 4 3.2 30
The following message is displayed:
ILMI polling timeout reconfigured
The polling interval of port 2 in slot 3 is set to 30 seconds and is saved to
flash.
(1) SET: Switch setup
(8) IME: ILMI setup
(5) POL: Polling setup
(4) STO: Set&Save Polling timeout
Format or Range
slot.port
Range: 5–1800 seconds
1 1 8 5 4 [parameters]
The polling interval for the specified port is updated
immediately and is saved in flash.
ILMI polling timeout reconfigured
ILMI Setup 139