Set Optimization For Cbr - 3Com CoreBuilder 7000 Management Manual

Set Optimization for
CBR
Updates the Constant Bit Rate (CBR) optimization parameter. A change to
the CBR optimization parameter takes place immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
constant bit rate
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 5 2 1 2
The following message is displayed:
Default Value is '3 - opt_ctd', New value is '2 - opt_av_cr'
Press ENTER to continue...
The value of the CBR optimization parameter is updated.
Setting Optimization Metrics
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(5) OPT: Optimization Metrics
(2) SOP: Set Optimization
Metrics
(1) OCR: Optimization for CBR
Format or Range
0 - 6
1 1 10 4 3 5 2 1 [parameters]
The CBR optimization parameter is displayed and is
updated to its new value.
Default value is <x>, new value is
<y>.
417