Update Admin-Access Password - 3Com CoreBuilder 7000 Management Manual

C 3: G
46
HAPTER ENERAL
Update Admin-Access
Password
T
ASKS
Updates the admin-access password. Enter the new password a second
time to confirm your entry. You are prompted for the existing password
before you enter the new password.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Old password
New password
New password again
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 1 3
The following dialog is displayed. Note that the passwords themselves are
not displayed.
Enter the old admin password: oldpass
Enter the new admin password: newpass
Enter the new admin password again: newpass
The password has been changed
The admin-access password is updated.
(1) SET: Switch setup
(1) PAS: Password setup
(3) ADM: Set Admin-access Password
Format or Range
Up to eight alphanumeric characters
Up to eight alphanumeric characters
Same password
1 1 1 3 [parameters]
The admin-access password is updated.
The password has been changed