Set Default Node Id - 3Com CoreBuilder 7000 Management Manual

C 13: C
390
HAPTER ONFIGURING AND

Set Default Node ID

M PNNI (F
ANAGING
Updates the ID of the PNNI node to the default address. A change to the
default node ID takes place after the next reboot.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 3 4 2
The following message is displayed:
PNNI Node 1 of 1. Node ID was set to DEFAULT:
48.A0.47.00.00.00.00.00.3C.00.00.00.00.00.00.00.C0.DA.60.27.
F6.FF
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(4) NID: Node ID
(2) SDF: Set Default Node ID
1 1 10 4 3 3 4 2
The current PNNI node id is set to the default address.
PNNI Node 1 of 1. Node ID was set to
DEFAULT: <address>
)
NLY