Update Ethernet Encapsulation Type - 3Com CoreBuilder 7000 Management Manual

Update Ethernet
Encapsulation Type
Enter a new value to update the Ethernet encapsulation type of the
CoreBuilder 7000 family ATM switch.
The options are:
1-ETH: Standard encapsulation - according to 802.3
0-LLC: Enhanced encapsulation
The Ethernet encapsulation type is updated after the next reboot of the
switch. For more information, see "Ethernet Encapsulation Type" on page
204 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Ethernet encapsulation
type
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 7 2 1
The following message is displayed:
Eth Type was successfully set for the next reboot.
Setting Up for Management
(1) SET: Switch setup
(2) MNG: Management setup
(7) ETH: Eth Type Setup
(2) SET: Set & save Eth Type
Format or Range
1 for type ETH
0 for type LLC
1 1 2 7 2 [parameters]
The Ethernet encapsulation type is updated after the
next reboot of the switch.
Eth Type was successfully set for the
next reboot.
83