3Com CoreBuilder 7000 Management Manual page 52

C 3: G
52
HAPTER ENERAL
T
ASKS
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Select module
Select data type
Server IP address
Name of file on server
Continue prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example - Downloading all configuration parameters
In this example, single-IP mode is enabled.
Enter:
1 3 7
1 Select the module whose configuration data you want to download from
disk from a list of the installed modules displayed according to slot
number. Enter to select the switch module:
1
Module Types:
Select Module: 1
(3) LOA: Load system s/w / config
(7) TCD: Download config from TFTP
server to flash
Format or Range
1–5
1–9
IP address
file name with path
y or n
1 3 7 [parameters]
The selected data of the selected module is
downloaded by TFTP from the server.
Information is displayed as shown in the example.
1<Switch module 7000>
2<Slot 3 - 7600 Fast>
3<Slot 4 - 7600 Fast>
4<Slot 5 - 7400 Ether>
5<Slot 6 - 7200 Ether>