Set Optimization For Ubr - 3Com CoreBuilder 7000 Management Manual

Set Optimization for
UBR
Updates the Unspecified Bit Rate (UBR) optimization parameter. A change
to the UBR optimization parameter takes place immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
constant bit rate
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 5 2 5 5
The following message is displayed:
Default Value is '0 - opt_admin_weight', New value is '5 -
opt_clr_clp0'
Press ENTER to continue...
The value of the UBR optimization parameter is updated to 5.
Setting Optimization Metrics
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(5) OPT: Optimization Metrics
(2) SOP: Set Optimization
Metrics
(5) OUR: Optimization for UBR
Format or Range
0 - 6
1 1 10 4 3 5 2 5 [parameters]
The UBR optimization parameter is displayed and is
updated to its new value.
Default value is <x>. New value is
<y>.
421