Update Signaling Protocol Profile - 3Com CoreBuilder 7000 Management Manual

C 7: C
202
HAPTER ONFIGURING
Update Signaling
Protocol Profile
V C
IRTUAL HANNELS
Updates the signaling protocol profile for the selected port for the current
session. For details, "Display Signaling Protocol Profile" on page 200.
This command causes the new signaling protocol parameters to be
activated in the current session. The new value is not stored in flash until
you use the SAV command ("Save Signaling Protocol Configuration" on
page 206).
If the new value of the signaling protocol parameters is not stored in
flash, the system reverts to the previous value of the signaling protocol
parameters the next time it reboots.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Signaling profile
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 5 2 3.2 1
The following message is displayed:
Parameter was set. Use 'SAVE' to save it on flash.
The signaling protocol for port 3.2 is updated to Network.
(1) SET: Switch setup
(4) SIG: Signaling setup
(5) SPS: Signaling protocol setup
(2) SPR: Set profile of port
Format or Range
slot.port (0.0 for all ports)
0 for user profile
1 for network profile
1 1 4 5 2 [parameters]
The signaling protocol profile is updated. for the
specified port.
Parameter was set.