Get Max Number Of Routes Per Cache - 3Com CoreBuilder 7000 Management Manual

C 13: C
444
HAPTER ONFIGURING AND
Get Max Number of
Routes per Cache
M PNNI (F
ANAGING
Displays the number of calls that can pass between a specific source and
any destination that has previously been accessed using the same route.
After this number of calls, the cache will be refreshed.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 6 5
The following message is displayed:
Num of calls to refresh the DTL cache is 40
Press ENTER to continue...
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(5) GMN: Get Max Number of Routes
1 1 10 4 6 5
The number of calls that can pass between a specific
source and any destination node using the same route
is displayed.
Num of calls to refresh the DTL cache
is <n>
)
NLY
per Cache