Configure Segment Id - 3Com CoreBuilder 7000 Management Manual

Configure Segment
ID
Configures a local segment ID for a token ring ELAN in the LECS
database. Specify the ELAN name.
Each token ring segment in a token ring network which uses source
routing must be assigned a unique segment ID by the network
administrator. You assign the segment ID to the ATM ELAN, which
simulates the token ring, by this command. Then, when a LEC joins the
ELAN, it gets the segment ID from the LECS. Alternatively, instead of
using this command, you can configure the segment ID manually in each
individual LEC in the ELAN.
You cannot assign a segment ID to a non-token ring ELAN.
To display the segment ID, see "Display ELAN Parameters in LECS
Database" on page 292.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
ELAN name
Segment ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
2 1 5 8elan73_9 133
The following message is displayed on the screen:
Segment id has been updated.
The segment ID is added to the LECS database.
LECS ELAN Database Operations
(2) LEM: LAN Emulation
(1) LCS: LE Configuration Services
(5) LNT: LECS Network topology
(8) SEG: Edit segment id
Format or Range
Up to 32 characters (see
290 in the Operations Guide
1-4096 (12 bit number)
2 1 5 8[parameters]
The segment ID is added to the LECS database.
Segment id has been updated.
"Display ELANs" on page
)
303