Set Max Number Of Routes Per Cache - 3Com CoreBuilder 7000 Management Manual

Set Max Number of
Routes per Cache
Sets the number of calls that can pass between a specific source and any
destination node that has previously been accessed using the same route.
After this number of calls, the cache will be refreshed. The default
number of calls is 40. A change to the number of calls takes place
immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Num of Calls
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 6 6 50
The following message is displayed:
Num of calls to refresh the DTL cache is 50
Press ENTER to continue...
Configuring the Route Cache
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(6) SMN: Set Max Number of Routes
per Cache
Format or Range
1 - 1000
1 1 10 4 6 6 [parameters]
The number of calls that can pass between a specific
source and any destination node using the same route
is updated.
Num of calls to refresh the DTL cache is <n>
445