Managing The Power Supply; Display Power Supply Info - 3Com CoreBuilder 7000 Management Manual

C 3: G
56
HAPTER ENERAL
Managing the
Power Supply
Display Power Supply
Info
T
ASKS
The following command allows you to manage the power supply unit for
the CoreBuilder 7000 family ATM switch.
Displays information about the power supplies installed in the
CoreBuilder 7000 family ATM switch chassis. Either one or two power
supplies may operate in the switch. When two power supplies are
installed, they work in a load-sharing mode; one takes over the whole
load in case the other fails. The screen displays the power supply slots'
occupancy and the status of the installed power supplies. The left-hand
power supply slot is designated as 1 and the right-hand slot as 2. See
"Redundant Power Supply" on page 85 in the Installation Guide for more
information about redundant power supplies.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Table 12 presents the possible status of the power supplies.
Table 12 Power Supply Status
Status
OK
Not installed
Fail
Example
Enter:
1 6
Information about the power supplies in the CoreBuilder 7000 family
ATM switch chassis is displayed.
Power supply id:
Power supply id:
(6) PWS: Power supplies
1 6
Information about power supplies in the CoreBuilder
switch is displayed.
Information is displayed as shown in the example.
Description
Power supply installed and working
No power supply installed in this slot.
The power supply is installed but not operational
because of missing AC connection or fault.
1 status: OK
2 status: Not installed