Enable/Disable Auto-Configuration - 3Com CoreBuilder 7000 Management Manual

Enable/Disable
Auto-Configuration
Enables or disables auto-configuration for the specified port in the
CoreBuilder 7000 family ATM switch. For more information about
auto-configuration, see "Auto-Configuration" on page 48 in the
Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Auto-configuration
enable/disable
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 2 2 3.2 1
The following message is displayed:
Auto-Configuration is set to ENABLED
The auto-configuration status of port 3.2 is enabled.
(1) SET: Switch setup
(8) IME: ILMI setup
(2) AUC: Auto-Configuration setup
(2) SET: Set&save Auto-Config stat
Format or Range
slot.port
0 to disable auto-configuration
1 to enable auto-configuration
[parameters]
1 1 8 2 2
Auto-configuration is enabled or disabled for the
selected port immediately and is saved in flash.
Auto-Configuration is set to
ENABLED/DISABLED
ILMI Setup 131