Set And Save Clock Mode - 3Com CoreBuilder 7000 Management Manual

Set and Save Clock
Mode
Sets and saves the clock operational mode of selected port as Internal or
External. You are prompted to specify a port and a mode. Not applicable
to DS-3 interfaces.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Interface Mode
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 5 1 5 3.2 1
The following message is displayed:
Setting clock operational mode for port <3.2> completed
successfully.
The clock operational mode of port <3.2> of the selected interface, a
OC-3 SC, is set to external and saved.
Set and Save Interface Mode
(5) IFC: Interface cards
(n) IFn; (n=1,4)
(5) STM: Set & save clock
op. mode
Format or Range
slot.port (0.0 - For all)
0 for Internal
1 for External
1 5 n 5 [parameters]
The clock operational mode of the selected port on the
interface card is set and saved.
Setting interface mode for port
<slot.port> completed successfully.
113