Delete ATM Address
from Port
Deletes an ATM address from the list of ATM addresses that were
configured by LMA at a port. Specify the ATM address by its member ID.
For a list of addresses registered by LMA together with their member IDs,
"Display Static ATM Addresses at Port" on page 153.
Perform the command Save ATM Addresses to Flash ( "Save ATM
Addresses to Flash" on page 162 ) before the next reboot to ensure that
your changes are saved.
Only ATM addresses created by LMA can be deleted by this command.
Command Actions
Enter the menu sequence: (3) CON: Connections
Enter a parameter at the prompt
Parameter
Member ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
3 4 2 3 3202
The ATM address with member ID 3202 is deleted from the MIB at the
port <3.2>.
(4) S&C: Setup and Config Conns
(2) STP: Atm address setup
(3) DEL: Delete ATM address
Format or Range
"slot""port""0n"
3 4 2 3 [parameters]
The specified ATM address is deleted from specified
port. The change is not saved in flash memory.
Information is displayed as shown in the example
below.
ILMI ATM Addresses
161