Set Cache State
Set the DTL cache state to ENABLED/DISABLED. The default cache state is
ENABLED. If the cache is disabled, it is not refreshed and calls are not
added to it. This means that for each incoming call, a new path will be
recalculated. A change to the DTL cache state takes place immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message is displayed:
PNNI
Press ENTER to continue...
Parameter
Cache state
1 1 10 4 6 2 1
cache ENABLED.
Configuring the Route Cache
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(2) SCS: Set Cache State
Format or Range
0 - enable
1 - disable
1 1 10 4 6 2
The DTL cache state is updated to disabled/enabled.
PNNI cache DISABLED/ENABLED.
441